AIR FUEL RATIO SENSOR > INSTALLATION |
| 1. INSTALL AIR FUEL RATIO SENSOR |
![]() |
Using SST, install the air fuel ratio sensor.
| *a | Fulcrum Length 30 mm (1.18 in.) |
| *b | Fulcrum Length 260 mm (10.2 in.) |
Connect the air fuel ratio sensor connector and 2 clamps.
| 2. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD) |
![]() |
Install the outer cowl top panel sub-assembly with the 8 bolts and nut.
Engage the clamp to install the wire harness.
| 3. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD) |
![]() |
Install the outer cowl top panel sub-assembly with the 8 bolts and nut.
Engage the 3 clamps to install the wire harness.
| 4. INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD) |
Engage the clamp to install the front No. 1 ventilator seal to the outer cowl top panel sub-assembly.
| 5. INSTALL FRONT NO. 1 VENTILATOR SEAL (for RHD) |
Engage the clamp to install the front No. 1 ventilator seal to the outer cowl top panel sub-assembly.
| 6. INSTALL FRONT AIR SHUTTER SEAL (for LHD) |
Engage the clamp to install the front air shutter seal to the outer cowl top panel sub-assembly.
| 7. INSTALL FRONT AIR SHUTTER SEAL (for RHD) |
Engage the clamp to install the front air shutter seal to the outer cowl top panel sub-assembly.
| 8. INSTALL INNER COWL TOP TO COWL BRACE (for LHD) |
![]() |
Install the inner cowl top to cowl brace to the outer cowl top panel sub-assembly with the 3 bolts.
| 9. INSTALL INNER COWL TOP TO COWL BRACE (for RHD) |
![]() |
Install the inner cowl top to cowl brace to the outer cowl top panel sub-assembly with the 3 bolts.
| 10. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |