Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here).


2. REMOVE INNER COWL TOP TO COWL BRACE (for LHD)


    C250011
  1. Remove the 3 bolts and inner cowl top to cowl brace.



3. REMOVE INNER COWL TOP TO COWL BRACE (for RHD)


    C249834
  1. Remove the 3 bolts and inner cowl top to cowl brace.



4. REMOVE FRONT AIR SHUTTER SEAL (for LHD)


    C250012
  1. Disengage the clamp to remove the front air shutter seal.



5. REMOVE FRONT AIR SHUTTER SEAL (for RHD)


    C249836
  1. Disengage the clamp to remove the front air shutter seal.



6. REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)


    C250013
  1. Disengage the clamp to remove the front No. 1 ventilator seal.



7. REMOVE FRONT NO. 1 VENTILATOR SEAL (for RHD)


    C249835
  1. Disengage the clamp to remove the front No. 1 ventilator seal.



8. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    C250014
  1. Disengage the clamp to separate the wire harness from the outer cowl top panel sub-assembly.



    C250015
  1. Remove the 8 bolts, nut and outer cowl top panel sub-assembly.



9. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    C256179
  1. Disengage the 3 clamps to separate the wire harness from the outer cowl top panel sub-assembly.



    C249838
  1. Remove the 8 bolts, nut and outer cowl top panel sub-assembly.



10. REMOVE AIR FUEL RATIO SENSOR


    A267409
  1. Disconnect the air fuel ratio sensor connector and 2 clamps.



    A267410E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010