Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAM POSITION SENSOR


    A235069
  1. Apply a light coat of engine oil to the O-ring on the cam position sensor.

  1. Install the cam position sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the cam position sensor connector.



2. INSPECT FOR OIL LEAK