Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the water filler cap sub-assembly, engine drain cock plug or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the water filler cap sub-assembly and drain the coolant.


    A267952E01


    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Engine Drain Cock Plug
    *4
    Water Filler

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A267960
  1. Remove the stop ring.



    A268695E01
  1. Connect the hose to the engine drain cock plug.
    Text in Illustration 
    *1
    Hose

  1. Pull out the engine drain cock plug and drain the coolant.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A267396
  1. Disconnect the ventilation hose.



    A267397
  1. Disconnect the purge VSV.



    A267398
  1. Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Release the 2 clamps.



    A267400
  1. Loosen the hose clamp and remove the air cleaner cap sub-assembly.



3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    A267401
  1. Disconnect the throttle body with motor connector and the 2 water by-pass hoses.



    A267402
  1. Remove the 3 bolts.

  1. Remove the throttle body with motor assembly.



    A267403
  1. Remove the gasket from the intake manifold.