Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > REMOVAL

for Preparation Click here



1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE HORN BUTTON ASSEMBLY
(Click here)


3. REMOVE STEERING WHEEL ASSEMBLY


    C252595E01
  1. Remove the steering wheel assembly set nut.
    Text in Illustration 
    *a
    Matchmark

  1. Put matchmarks on the steering wheel assembly and steering main shaft.

  1. Disconnect the connectors from the spiral cable.



    C252596E01
  1. Using SST, remove the steering wheel assembly.
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05070)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



4. REMOVE STEERING PAD SWITCH ASSEMBLY


    C241120
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the steering pad switch assembly (RH side) from the steering wheel sub-assembly.



    C241121
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the steering pad switch assembly (LH side) from the steering wheel sub-assembly.



5. REMOVE CRUISE CONTROL MAIN SWITCH


    E244460
  1. Disconnect the connector.



    E244461
  1. Remove the 2 screws and cruise control switch.



6. REMOVE CRUISE CONTROL SWITCH WIRE


7. REMOVE LOWER STEERING WHEEL BOSS COVER


    C206252
  1. Disengage the 2 pins and 4 claws to remove the lower steering wheel boss cover from the steering wheel sub-assembly.