Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Rear Side)

WASHER MOTOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


    E238033
  1. Remove the 2 screws and front wheel opening extension pad RH.



3. REMOVE FRONT FENDER LINER RH


    E238034
  1. Remove the 3 screws.



    E238036
  1. Remove the 4 grommets.



    E238035
  1. Remove the 7clips and front fender liner RH.



4. DRAIN WINDSHIELD WASHER FLUID


    E237559
  1. Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



5. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY


    E237560
  1. Disconnect the connector.

  1. Remove the rear washer motor and pump assembly as shown in the illustration.

    HINT:
    Use a container to collect the washer fluid.



6. REMOVE REAR WASHER JAR BUSH


    E237561
  1. Remove the rear washer jar bush from the washer jar.