Home › Vehicle Interior › POWER OUTLETS (INT) › POWER OUTLET SOCKET

POWER OUTLET SOCKET > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONER CONTROL ASSEMBLY
(Click here)


2. REMOVE RADIO TUNER OPENING COVER WITH BRACKET (w/o Radio Receiver)


    B307678
  1. Remove the 4 screws <C> and radio tuner opening cover with bracket.



3. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)


    E244891
  1. Remove the 4 screws.



    E244892
  1. Disengage the 2 guides and pull the radio receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio receiver assembly with bracket.



4. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY


    E239791
  1. Disconnect the connector.



    E240051E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw, then turn the No. 1 power outlet socket assembly clockwise and pull the No. 1 power outlet socket assembly half way out.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    E240052
  1. Align the protrusion of the No. 1 power outlet socket assembly with the cutout of the No. 1 power outlet socket cover and then pull the No. 1 power outlet socket assembly out.

  1. Remove the No. 1 power outlet socket assembly.



5. REMOVE NO. 1 POWER OUTLET SOCKET COVER


    E240053
  1. Disengage the 2 claws and remove the No. 1 power outlet socket cover.