Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


  1. Using an air riveter or a hand riveter, install the front No. 1 speaker assembly with 3 new rivets.


    E244888E01


    Text in Illustration 
    *1
    Riveter
    *2
    Mandrel
    *a
    INCORRECT
    *b
    CORRECT

    NOTICE:
    1. Do not touch the cone part of the speaker.
    2. Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
    3. Confirm that the rivets are seated properly against the speaker.
    4. Do not tilt the riveter when installing the rivets to the speaker.
    5. Do not leave any clearance between the rivet heads and speaker.
    6. Do not leave any clearance between the speaker and door. Firmly hold the 2 items together while installing the rivets.

    HINT:
    1. Install the rivets in the order shown in the illustration.
    2. If the rivet cannot be cut, pull it once and cut it.

  1. Connect the connector.



2. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
  1. Install the front No. 2 speaker assembly with the 2 screws.

    NOTICE:
    Do not touch the cone part of the speaker.

  1. Connect the connector.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B307126E02
  1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly to the front door inside handle.
    Text in Illustration 
    *1
    Front Door Inside Locking Cable Assembly
    *2
    Front Door Lock Remote Control Cable Assembly



    B307169
  1. Engage the 8 clips.



    B307081
  1. Install the front door trim board sub-assembly with the 3 screws.



    B307127
  1. Engage the claw and close the cover.



4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
  1. Connect the connector.



    B307078
  1. Engage the 4 guides and 10 claws to install power window regulator master switch assembly with front door armrest base panel.



5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
  1. Connect the connector.



    B307079
  1. Engage the 4 guides and 10 claws to install power window regulator switch assembly with front door armrest base panel.