Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER

REAR DOOR SPEAKER > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR FRAME GARNISH


    B307128
  1. Disengage the 2 clips and 3 claws.

  1. Disengage the guide and remove the rear door frame garnish.



2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    B307129
  1. Disengage the 8 claws and 3 guides.

  1. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B307133E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
    Text in Illustration 
    *1
    Protective Tape



    B307134
  1. Remove the 3 screws.



    B308235
  1. Disengage the clip.



  1. pull the rear door trim board sub-assembly at the position indicated in the illustration and disengage the 7 clips in the order shown in the illustration.


    B307908

    NOTICE:
    Do not apply excessive force when pulling the rear door trim board sub-assembly.



    B307135E01
  1. Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly and remove the rear door trim board.
    Text in Illustration 
    *1
    Rear Door Inside Locking Cable Assembly
    *2
    Rear Door Lock Remote Control Cable Assembly



4. REMOVE REAR SPEAKER ASSEMBLY


    E237145
  1. Disconnect the connector.



    E237146
  1. Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

    NOTICE:
    1. Do not touch the cone part of the speaker.
    2. Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
    3. Be careful as the cut rivet will be very hot.

  1. Continue drilling and push out the remaining rivet fragments.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.