Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM
  1. Start the hybrid system.

  1. Operate the cooler compressor under the conditions show below:
    Item
    Condition
    Engine Speed
    Idling
    Operating Time
    3 minutes or more
    A/C Switch Status
    ON
    Blower Switch Status
    HI
    Set Temperature
    MAX COOL
    This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

    HINT:
    It is not necessary to operate the cooler compressor if the A/C does not operate because of compressor lock, etc.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    HINT:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE AIR CONDITIONER PRESSURE SENSOR


    E234950
  1. Disconnect the connector.



    E234951E01
  1. Using a deep socket wrench 27 mm, remove the air conditioner pressure sensor.
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.