REAR CENTER SEAT OUTER BELT ASSEMBLY > REMOVAL |
| 1. REMOVE REAR SEAT HEADREST ASSEMBLY |
| 2. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY |
| 3. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 4. REMOVE FRONT FLOOR COVER LH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover LH.
| 5. REMOVE FRONT CENTER FLOOR COVER |
![]() |
Using a clip remover, remove the 3 clips.
Disengage the 2 guides and remove the front center floor cover.
| 6. REMOVE REAR SEATBACK ASSEMBLY RH |
Fold down the rear seatback assembly RH.
![]() |
Remove the 2 bolts and rear seatback assembly RH.
| 7. REMOVE REAR SEAT CUSHION ASSEMBLY |
![]() |
Disengage the 2 clips.
| *a | RH Side |
| *b | LH Side |
![]() |
Disengage the hook of the rear seat cushion assembly from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 8. REMOVE REAR DOOR SCUFF PLATE RH |
| 9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 10. REMOVE DECK BOARD ASSEMBLY |
Remove the deck board assembly.
| 11. REMOVE DECK FLOOR BOX LH |
Remove the deck floor box LH.
| 12. REMOVE DECK FLOOR BOX RH |
| 13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY |
Remove the package tray trim panel assembly.
| 14. REMOVE REAR DECK TRIM COVER |
![]() |
Remove the 2 clips.
Disengage the 4 claws and 2 guides, and remove the rear deck trim cover.
| 15. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH |
| 16. REMOVE REAR ABSORBER CAP RH |
| 17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
| 18. DISCONNECT REAR CENTER SEAT LAP TYPE BELT ASSEMBLY |
![]() |
Using a moulding remover, disengage the 2 claws and open the cover.
![]() |
Loosen the bolt and disconnect the shoulder anchor of the rear center seat lap type belt assembly.
| 19. REMOVE ROOF SIDE INNER GARNISH RH |
![]() |
Using a moulding remover, disengage the 4 claws and guide, and disconnect the belt guide.
Disengage the 5 clips.

Pass the floor anchor of the rear seat 3 point type outer belt assembly RH through the roof side inner garnish RH and remove the roof side inner garnish RH.
| 20. REMOVE REAR CENTER SEAT LAP TYPE BELT ASSEMBLY |
![]() |
Remove the bolt.
![]() |
Disengage the guide.
Turn the shoulder anchor counterclockwise approximately 90° and pull it out.
![]() |
Remove the bolt.
Disengage the 2 guides and remove the rear center seat lap type belt assembly.