Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT

ROOM LIGHT > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY


    E252614E03
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws to remove the No. 1 room light lens.
    Text in Illustration 
    *a
    Protective Tape
    *b
    Front



    E252615E02
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws as shown in the illustration to separate the No. 1 room light housing.
    Text in Illustration 
    *a
    Protective Tape
    *b
    Front



    E252618E01
  1. Disengage the clamp.
    Text in Illustration 
    *1
    Room Light Switch Base

  1. Using a screwdriver, disengage the 4 claws to disconnect the room light switch base from the No. 1 room light housing.



2. REMOVE NO. 1 ROOM LIGHT BULB
  1. Remove the No. 1 room light bulb from the room light switch base.