Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER MIRROR


    B307653E01
  1. Push the upper part of the outer mirror surface and tilt it.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover

  1. Apply protective tape to the lower of the outer rear view mirror assembly with cover.

  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror assembly with cover, and separate the outer mirror.

    NOTICE:
    Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

  1. Push the lower part of the mirror surface and tilt it.



    B307654E01
  1. Apply protective tape to the upper of the outer rear view mirror assembly with cover.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover

  1. Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror assembly with cover, and remove the outer mirror.

    NOTICE:
    Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.



2. REMOVE OUTER MIRROR COVER


    B307655
  1. Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.



    B307660
  1. Remove the screw.

  1. Disengage the guide and remove the visor inner cover.



    B307656
  1. Disengage the claw at bottom of the outer rear view mirror assembly.



    B307657
  1. Disengage the 4 claws and remove the outer mirror cover.



3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    E237710
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the side turn signal light assembly.