REAR COMBINATION LIGHT ASSEMBLY > REMOVAL |
| 1. REMOVE REAR COMBINATION LIGHT ASSEMBLY |
![]() |
Apply protective tape, as shown in the illustration.
![]() | Protective Tape |
![]() |
Remove the bolt.
Disengage the 2 clips.
Pull the deck trim side panel assembly until the connector of the rear combination light assembly can be seen.
Disconnect the connector.
![]() |
Remove the 2 bolts.
| *a | Pin |
| *b | Guide |
![]() |
Pull the upper surface of the rear combination light assembly towards the rear of the vehicle and disengage the pin on the upper side.
Pull the lower surface of the rear combination light assembly towards the rear of the vehicle and disengage the pin on the lower side and the guide.
![]() |
Disengage the grommet and remove the rear combination light assembly.