Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B297006
  1. Remove the 10 clips and back door trim board assembly.



2. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E237720
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the license plate light assembly.



3. REMOVE LICENSE PLATE LIGHT PACKING
  1. Remove the license plate light packing.

    NOTICE:
    Do not reuse the removed packing. Be sure to install a new license plate light packing to prevent water ingress.



4. REMOVE LICENSE PLATE LIGHT LENS


    E248509
  1. Using a screwdriver, disengage the 2 claws and remove the license plate light lens from the housing.



5. REMOVE LICENSE PLATE LIGHT BULB
  1. Remove the license plate light bulb from the housing.