Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    E167768
  1. Insert the stop light switch assembly until the threaded sleeve hits the pedal.

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



    E236346E01
  1. Make a quarter turn clockwise to install the stop light switch assembly.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

  1. Connect the connector.

  1. Check the protrusion of the plunger.
    Protrusion of Plunger 
    Area
    Measurement
    a
    0.5 to 2.6 mm (0.0197 to 0.102 in.)
    If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (Click here for LHD or Click here for RHD).

    NOTICE:
    Do not depress or support the brake pedal.