HEADLIGHT LEVELING ECU > INSTALLATION |
| 1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY |
Engage the guide.
Install the headlight leveling ECU assembly with the bolt.
Connect the connector.
| 2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
| *a | Opened approximately 55° |
| *b | Closed |
![]() |
Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
| *1 | Glove Compartment Door Stopper Sub-assembly |
Engage the claw and connect the glove compartment door stopper sub-assembly.
| 3. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY |
| 4. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL |
| 5. ADJUST HEADLIGHT AIMING |