Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU

HEADLIGHT LEVELING ECU > REMOVAL

for Preparation Click here



1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY
(Click here)


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B307685E01
  1. Disengage the claw and release the glove compartment door stopper sub-assembly.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly

  1. Slightly bend the stopper (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.



    B307687E01
  1. Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.
    Text in Illustration 
    *a
    Closed
    *b
    Open Approximately 55°

    NOTICE:
    Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.



3. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY


    E237736
  1. Disconnect the connector.

  1. Remove the bolt.

  1. Disengage the guide and remove the headlight leveling ECU assembly.