Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT PRELOAD


    C248051E01
  1. Secure the steering column assembly in a vice using aluminum plates and wooden block as shown in the illustration.
    Text in Illustration 
    *1
    Aluminum Plate
    *2
    Wooden Block

    NOTICE:
    When using a vise, do not overtighten it.



    C249608E01
  1. Using SST and a torque wrench, turn the main shaft at a constant speed of approximately 1 revolution every 4 seconds and measure the preload.

    SST
    09616-00011  

    Torque:
    Preload:
    1.4 N*m{ 14 kgf*cm , 12 in.*lbf } or less

    If the preload is not as specified, replace the power steering motor assembly or electric power steering column sub-assembly with a new one.



2. INSPECT STEERING COLUMN ASSEMBLY


    C235885
  1. Check that the 2 bushings are securely installed to the steering column assembly.
    If the bushings are deformed, missing or damaged, replace the electric power steering column sub-assembly with a new one.



    C234253E02
  1. Check that the 2 capsules are securely installed to the electric power steering column sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Capsule
    *a
    OK
    *b
    NG

    Standard:
    Capsules do not overlap the corner parts of the brackets.

    NOTICE:
    1. If the standard value is not satisfied, replace the electric power steering column sub-assembly with a new one.
    2. If the capsules have deformation, damage or misalignment, replace the electric power steering column sub-assembly with a new one.