Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise SET Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. The hybrid vehicle control ECU turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.
  2. The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.
  3. The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM

Refer to Cruise Main Indicator Light Circuit .

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. Check the cruise control SET indicator light by performing the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. SET
    Cruise control SET indicator light
    Cruise control SET indicator light ON / OFF
    -

    OK:
    The cruise control SET indicator light goes on or goes off.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)