Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for LED Headlight)

HEADLIGHT ASSEMBLY (for LED Headlight) > REPAIR

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.
  4. Ensure that the headlight assembly is not damaged.



1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


    E247288
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



    E247289
  1. Install the upper headlight protector retainer with the 2 screws.



2. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER


    E247292
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



    E247293
  1. Install the lower headlight protector retainer with the 2 screws.



3. INSTALL LOWER HEADLIGHT BRACKET


    E247290
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the lower headlight bracket against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



    E247291
  1. Install the lower headlight bracket with the 3 screws.