Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART ENTRY AND START SYSTEM (for Start Function)

DTC    U0140    Lost Communication with Main Body ECU

DTC    U0142    Lost Communication with Main Body ECU

DTC    U0155    Lost Communication with Combination Meter

DTC    U0293    Lost Communication with HV ECU

for Preparation Click here


DESCRIPTION

These DTCs are stored when there is a CAN communication error between the certification ECU (smart key ECU assembly) and the ECM, main body ECU (multiplex network body ECU), combination meter assembly or hybrid vehicle control ECU.

HINT:
When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.


DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
U0140
CAN communication error between the certification ECU (smart key ECU assembly) and main body ECU (1-trip detection logic*)
Main body ECU (Multiplex network body ECU)
Always
U0142
CAN communication error between the certification ECU (smart key ECU assembly) and main body ECU (1-trip detection logic*)
Main body ECU (Multiplex network body ECU)
Always
U0155
CAN communication error between the certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection logic*)
Combination meter assembly
Turn the power switch on (IG) and wait 10 seconds or more.
U0293
CAN communication error between the certification ECU (smart key ECU assembly) and hybrid vehicle control ECU (1-trip detection logic*)
Hybrid vehicle control ECU
Turn the power switch on (IG) and wait 10 seconds or more.
  1. *: Only detected while a malfunction is present and the power switch is on (IG)

Vehicle Condition and Fail-safe Function when Malfunction Detected 
DTC Code
Vehicle Condition when Malfunction Detected
Fail-safe Function when Malfunction Detected
U0140
The warning (meter buzzer) does not sound and the meter does not indicate a warning.
-
U0142
  1. Doors cannot be locked or unlocked. The warning (wireless buzzer) does not sound.
  2. The warning (meter buzzer) does not sound and the meter does not indicate a warning.
-
U0155
  1. The warning (meter buzzer) does not sound and the meter does not indicate a warning. (When the smart key ECU stores the DTC.)
  2. There is no effect on vehicle behavior. (When the smart key ECU stores the DTC.)
-
U0293
The warning (meter buzzer) does not sound and the meter does not indicate a warning.
-

INSPECTION PROCEDURE

NOTICE:
  1. When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle, select the vehicle type under manual mode, and then enter the following menus:
    for Power Source Control: Body / Power Source Control / DTC.
    for Entry&Start: Body / Entry&Start / DTC.
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.


HINT:

Related Data List and Active Test Items 
DTC
Data List Item
Active Test Item
U0140
U0142
U0155
U0293
-
-

1.CHECK FOR DTC
  1. Note any DTCs that are output (Click here).


NEXT

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)