DTC B27A8 Open in Outside Luggage Compartment Electrical Key Antenna Circuit |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B27A8 | An open circuit is detected in the circuit between the certification ECU (smart key ECU assembly) and electrical key antenna (outside luggage) (CLG8 - ANTE8, CG8B - CLGB) (1 trip detection logic*). |
| Any time |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Entry lock or unlock operation cannot be performed for luggage compartment door | - |
| DTC Code | Data List and Active Test |
| B27A8 | Key diagnostic mode can be used to perform troubleshooting |

| 1.CHECK CONNECTOR CONNECTION |
Turn the power switch off.
Check that the connectors are properly connected to the certification ECU (smart key ECU assembly) and electrical key antenna (outside luggage).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ELECTRICAL KEY ANTENNA - CERTIFICATION ECU) |
Disconnect the G53 and G55 certification ECU (smart key ECU assembly) connectors.
Disconnect the M19 electrical key antenna (outside luggage) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G53-2 (CLG8) - M19-1 (ANTE8) | Always | Below 1 Ω |
| G53-1 (CG8B) - M19-2 (CLGB) | Always | Below 1 Ω |
| G53-2 (CLG8) or M19-1 (ANTE8) - Body ground | Always | 10 kΩ or higher |
| G53-1 (CG8B) or M19-2 (CLGB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE) |
![]() |
Remove the electrical key antenna (outside luggage) (Click here).
| *a | Component without harness connected (Electrical Key Antenna (Outside Luggage)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (ANTE8) - 2 (CLGB) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Temporarily replace the certification ECU (smart key ECU assembly) with a new one.
| NEXT | |
| 5.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 6.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||