CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION |
| 1. INSTALL AIRBAG SENSOR ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Using SST, install the airbag sensor assembly with the 3 bolts.

| *a | Fulcrum Length | - | - |
![]() |
Connect the connectors to the airbag sensor assembly as shown in the illustration.
Check that the waterproof sheet is properly set.
| *1 | Waterproof Sheet |
Check that there is no looseness in the installation parts of the airbag sensor assembly.
Connect the air conditioning amplifier assembly connector.
| 2. INSTALL REAR CONSOLE BOX ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. INSTALL FRONT FLOOR COVER RH |
| 5. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 6. INSPECT SRS WARNING LIGHT |
| 7. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION |