CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 5. REMOVE AIRBAG SENSOR ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Disconnect the air conditioning amplifier assembly connector.
![]() |
Disconnect the connectors from the airbag sensor assembly as shown in the illustration.
![]() |
Remove the 3 bolts and airbag sensor assembly.