TRANSMITTER BATTERY > REPLACEMENT |
| 1. REMOVE TRANSMITTER BATTERY (w/o Tire Pressure Warning System) |
![]() |
Push the release hook knob and remove the mechanical key as indicated by the arrows, in the order shown in the illustration.
![]() |
Insert a screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.
| *a | Protective Tape |
![]() |
Insert a precision screwdriver into the gap and gently remove the transmitter battery (lithium battery: CR1632).
| *a | Protective Tape |
| 2. REMOVE TRANSMITTER BATTERY (w/ Tire Pressure Warning System) |
![]() |
Push the release hook knob and remove the mechanical key as indicated by the arrows, in the order shown in the illustration.
![]() |
Insert a screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.
| *a | Protective Tape |
![]() |
Insert a precision screwdriver into the gap and gently remove the transmitter battery (lithium battery: CR2032).
| *a | Protective Tape |
| 3. INSTALL TRANSMITTER BATTERY (w/o Tire Pressure Warning System) |
![]() |
Install a new transmitter battery (lithium battery: CR1632) with the positive (+) side facing upward as shown in the illustration.
![]() |
Install the transmitter housing cover by pressing down on it as shown in the illustration.
![]() |
Insert the mechanical key into the transmitter as shown in the illustration.
Press one of the transmitter switches and check that the LED illuminates.
| 4. INSTALL TRANSMITTER BATTERY (w/ Tire Pressure Warning System) |
![]() |
Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.
![]() |
Install the transmitter housing cover by pressing down on it as shown in the illustration.
![]() |
Insert the mechanical key into the transmitter as shown in the illustration.
Press one of the transmitter switches and check that the LED illuminates.