Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

    NOTICE:
    Do not use a moulding remover to an area other than that shown in the illustration. Using a moulding remover in an area other than that shown in the illustration may result in deformation or damage to related parts.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



2. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E244239
  1. Disengage the 2 claws and remove the hazard warning signal switch assembly from the center instrument cluster finish panel sub-assembly.