POWER WINDOW REGULATOR MOTOR (for Rear Door) > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE REAR DOOR FRAME GARNISH |
![]() |
Disengage the 2 clips and 3 claws.
Disengage the guide and remove the rear door frame garnish.
| 5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
![]() |
Disengage the 8 claws and 3 guides.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
| 6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
| *1 | Protective Tape |
![]() |
Remove the 3 screws.
![]() |
Disengage the clip.
pull the rear door trim board sub-assembly at the position indicated in the illustration and disengage the 7 clips in the order shown in the illustration.

![]() |
Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly and remove the rear door trim board.
| *1 | Rear Door Inside Locking Cable Assembly |
| *2 | Rear Door Lock Remote Control Cable Assembly |
| 7. REMOVE REAR DOOR SERVICE HOLE COVER |
![]() |
Remove the rear door service hole cover.
| 8. DISCONNECT REAR DOOR WEATHERSTRIP |
Disconnect the upper part of rear door weatherstrip.
| 9. REMOVE REAR DOOR GLASS RUN |
![]() |
Remove the rear door glass run.
| 10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and screw, and remove the rear door window division bar sub-assembly.
| 11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
Slide the lower section of the rear door glass and disengage the rear door glass from the rear window regulator sub-assembly.
Remove the rear door glass sub-assembly as indicated by the arrows in the order shown in the illustration.
| 12. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY |
![]() |
Disconnect the connector.
| *1 | Temporary Bolt |
Loosen the temporary bolt.
Remove the 3 bolts and rear door window regulator assembly.
Remove the temporary bolt from the rear door window regulator assembly.
| 13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY |
![]() |
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.