Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER

NOISE FILTER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT RADIO SETTING CONDENSER
  1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

  1. Remove the bolt.

  1. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.



    E230106E01
  1. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

    NOTICE:
    Before measuring the resistance and voltage, be sure to use insulated probes to avoid a short circuit between the tester terminal and bracket.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    1. Power switch off
    2. Window defogger off
    10 kΩ or higher
    3 - Body ground
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    1. Power switch on (IG)
    2. Window defogger off
    Below 1 V
    1 - Body ground
    1. Power switch on (IG)
    2. Window defogger on
    11 to 14 V

    Text in Illustration 
    *a
    Radio Setting Condenser
    If the result is not as specified, replace the radio setting condenser.