Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › EGR VALVE

EGR VALVE > REMOVAL

for Preparation Click here



1. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the water filler cap sub-assembly, engine drain cock plug or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the water filler cap sub-assembly and drain the coolant.


    A267952E01


    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Engine Drain Cock Plug
    *4
    Water Filler

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A267960
  1. Remove the stop ring.



    A268695E01
  1. Connect the hose to the engine drain cock plug.
    Text in Illustration 
    *1
    Hose

  1. Pull out the engine drain cock plug and drain the coolant.



2. REMOVE NO. 2 EGR PIPE


    A268229
  1. Disconnect the wire harness clamp.

  1. Disengage the clamp and disconnect the No. 2 water by-pass hose.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the No. 2 EGR pipe and 2 gaskets.



3. REMOVE EGR VALVE ASSEMBLY


    A267673
  1. Disconnect the 2 connectors and wire harness clamp.



    A267672
  1. Remove the bolt and wire harness clamp bracket.



    A266465
  1. Disengage the clamp and disconnect the No. 5 water by-pass hose.

  1. Remove the 2 bolts, nut and EGR valve bracket.



    A266466
  1. Disconnect the No. 1 water by-pass hose.



    A267671
  1. Using an E8 "TORX" socket wrench, remove the 2 stud bolts.



    A266463
  1. Remove the 2 bolts, EGR valve assembly and gasket.