VACUUM SENSOR > REMOVAL |
| 1. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the ventilation hose.
![]() |
Disconnect the purge VSV.
![]() |
Disconnect the mass air flow meter connector.
Disconnect the wire harness clamp.
Release the 2 clamps.
![]() |
Loosen the hose clamp and remove the air cleaner cap sub-assembly.
| 2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
Remove the air cleaner filter element sub-assembly.
![]() |
Remove the 2 bolts, grommet and air cleaner case sub-assembly.
| 3. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR |
![]() |
Disconnect the connector.
Remove the bolt and manifold absolute pressure sensor.