BRAKE BOOSTER PUMP (for LHD) > INSTALLATION |
| 1. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY |
Engage the clamp to install the frame wire to the brake actuator bracket assembly.
![]() |
Install the brake actuator bracket assembly with the 3 bolts.
Engage the 2 clamps to install the frame wire to the brake actuator bracket assembly.
| 2. INSTALL ENGINE UNDER COVER LH |
| 3. INSTALL FRONT WHEEL LH |
| 4. INSTALL BRAKE BOOSTER PUMP ASSEMBLY |
![]() |
Install the brake booster pump assembly to the brake actuator bracket assembly with the 2 brake booster pump bushings, 2 brake actuator case collars and 2 nuts.
| *1 | Union |
| *2 | Connector |
| *3 | Stud |
| *4 | Brake Booster Pump Collar |
| *5 | Brake Booster Pump Bushing |
| *6 | Brake Actuator Bracket Cushion |
Connect the 2 connectors to the brake booster pump assembly.
| 5. INSTALL NO. 1 BRAKE TUBE CLAMP BRACKET |
Install the No. 1 brake tube clamp bracket to the brake booster pump assembly with the bolt.
| 6. INSTALL FRONT NO. 1 BRAKE TUBE |
Temporarily tighten the union nut of the front No. 1 brake tube to the brake booster pump assembly.
Install the bolt to secure the front No. 1 brake tube to the No. 1 brake tube clamp bracket.
Using a union nut wrench, fully tighten the front No. 1 brake tube.
| 7. INSTALL BRAKE ACTUATOR HOSE |
![]() |
Connect the brake actuator hose to the brake booster pump assembly.
| *A | for Type A |
| *B | for Type B |
| *a | Identification Mark (Red) |
| *b | Identification Mark (Yellowish Green) |
| *c | Rib (Unpainted) |
Move the clip to secure the brake actuator hose.

| *A | for Type A | *B | for Type B |
![]() | Front of Vehicle | - | - |
| 8. INSTALL BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY |