Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER PUMP (for LHD)

BRAKE BOOSTER PUMP (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
(Click here)


2. REMOVE BRAKE ACTUATOR HOSE


    C268181E01
  1. Move the clip and remove the brake actuator hose from the brake booster pump assembly.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B



3. REMOVE FRONT NO. 1 BRAKE TUBE


    C268182E01
  1. Remove the bolt.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B

  1. Using a union nut wrench, disconnect the brake line to remove the front No. 1 brake tube from the brake booster pump assembly.



4. REMOVE NO. 1 BRAKE TUBE CLAMP BRACKET


    C268183E01
  1. Remove the bolt and No. 1 brake tube clamp bracket from the brake booster pump assembly.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B



5. REMOVE BRAKE BOOSTER PUMP ASSEMBLY


    C250035
  1. Disconnect the 2 connectors from the brake booster pump assembly.



    C249857E01
  1. Remove the 2 nuts, brake booster pump assembly, 2 brake actuator case collars and 2 brake booster pump bushings from the brake actuator bracket assembly.
    Text in Illustration 
    *1
    Union
    *2
    Connector
    *3
    Stud

    NOTICE:
    1. Do not carry the brake booster pump assembly by the parts shown in bold (*1, *2 and *3) in the illustration.
    2. Do not drop the brake booster pump assembly when carrying it. If the brake booster pump assembly has been dropped, replace it with a new one.
    3. Be careful not to allow any brake fluid to enter the connector.
    4. Do not kink or damage the brake lines. If they are damaged, replace them with new ones.



6. REMOVE FRONT WHEEL LH


7. REMOVE ENGINE UNDER COVER LH


8. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY


    C250036
  1. Disengage the 2 clamps to separate the frame wire from the brake actuator bracket assembly.



    C249860
  1. Remove the 3 bolts and brake actuator bracket assembly.



    C256174
  1. Disengage the clamp to separate the frame wire from the brake actuator bracket assembly.

    NOTICE:
    Do not kink or damage the brake lines.