COMBINATION SWITCH > INSPECTION |
| 1. INSPECT EV DRIVE MODE SWITCH (PATTERN SELECT SWITCH ASSEMBLY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G63-4 (S) - G63-1 (E) | EV drive mode switch (pattern select switch assembly) being pushed and held | Below 1 Ω |
| G63-4 (S) - G63-1 (E) | EV drive mode switch (pattern select switch assembly) not pushed | 10 kΩ or higher |
| *a | Component without harness connected (EV Drive Mode Switch (Pattern Select Switch Assembly)) |
![]() |
Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch (pattern select switch assembly).
| Measurement Condition | Specified Condition |
| Auxiliary battery positive (+) → G63-3 (ILL+) Auxiliary battery negative (-) →G63-2 (ILL-) | Illuminates |
| *a | Component without harness connected (EV Drive Mode Switch (Pattern Select Switch Assembly)) |