Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE APPROACHING SPEAKER SWITCH

VEHICLE APPROACHING SPEAKER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT VEHICLE APPROACHING SPEAKER SWITCH


    E342322E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G84-1 (ECU) - G84-4 (IG)
    Vehicle approaching speaker switch being pushed and held
    Below 1 Ω
    G84-1 (ECU) - G84-4 (IG)
    Vehicle approaching speaker switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Vehicle Approaching Speaker Switch)
    If the result is not as specified, replace the vehicle approaching speaker switch.



    E342322E02
  1. Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the vehicle approaching speaker switch.

    OK:
    Measurement Condition
    Specified Condition
    Auxiliary battery positive (+) → G84-3 (ILL+)
    Auxiliary battery negative (-) → G84-2 (ILL-)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Vehicle Approaching Speaker Switch)
    If the result is not as specified, replace the vehicle approaching speaker switch.