POWER WINDOW CONTROL SYSTEM > Power Windows do not Operate Using All Window Switch |


| 1.CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND) |
Disconnect the power window regulator master switch assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J1-6 (B) - Body ground | Power switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| H1-6 (B) - Body ground | Power switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| J1-1 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| H1-9 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Replace the power window regulator master switch assembly (Click here).
| NEXT | |
| 3.CHECK POWER WINDOW CONTROL SYSTEM |
Check the power windows operation by using the power window regulator master switch assembly and power window regulator switch assemblies.
|
| ||||
| OK | ||
| ||