Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Non-removable Headrest)

FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Non-removable Headrest) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
  1. Do not reuse the nuts.
  2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.

  1. Install the front seat airbag assembly with 2 new nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Engage the 2 clamps.



2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
  1. Temporarily install the separate type front seatback cover with pad.

  1. Install the 3 brackets with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    1. For vehicles with a front seat airbag assembly, the separate type front seatback cover must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.
    2. Make sure that the strap is not twisted after installing the nut.
    3. Install the bracket securely.



    B296404
  1. Turn back the separate type front seatback cover.



    B396050
  1. Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.



    B296402
  1. Using hog ring pliers, install 3 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.



    B311802
  1. Using hog ring pliers, install 5 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.



3. CONNECT FRONT SEAT AIRBAG ASSEMBLY
  1. for Driver Side:

    1. Engage the claw and 6 clamps to install the front seat airbag assembly wire harness.

  1. for Front Passenger Side:

    1. Engage the claw and 3 clamps to install the front seat airbag assembly wire harness.

  1. Engage the fastener to secure the front seat airbag assembly wire harness.



4. CONNECT SEPARATE TYPE FRONT SEATBACK COVER
  1. Connect the rubber band of the separate type front seatback cover.



5. INSTALL FRONT SEAT ASSEMBLY
(Click here)


6. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)