Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Non-removable Headrest)

FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Non-removable Headrest) > REMOVAL

for Preparation Click here


CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. Wear protective gloves. Sharp areas on the parts may injure your hands.
  3. If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage (Click here).

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER


    B299149
  1. Disconnect the rubber band of the separate type front seatback cover.



3. SEPARATE FRONT SEAT AIRBAG ASSEMBLY


    B301352
  1. Disengage the fastener and separate the front seat airbag assembly wire harness.



  1. for Driver Side:



      B296414
    1. Disengage the claw and 6 clamps to separate the front seat airbag assembly wire harness.



  1. for Front Passenger Side:



      B296413
    1. Disengage the claw and 3 clamps to separate the front seat airbag assembly wire harness.



4. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    B299151
  1. Remove the 5 hog rings.



    B296401
  1. Remove the 3 hog rings.



    B396049
  1. Remove the 2 hog rings.



    B296403
  1. Turn back the separate type front seatback cover.



    B299152
  1. Remove the 2 nuts and the 3 brackets.

  1. Remove the separate type front seatback cover with pad.



5. REMOVE FRONT SEAT AIRBAG ASSEMBLY


    B300261
  1. Disengage the 2 clamps.

  1. Remove the 2 nuts and front seat airbag assembly.

    CAUTION:
    1. Do not reuse the nuts.
    2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.