Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL SWITCH

DOOR CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


  1. Check the operation of the power window regulator master switch assembly. (for LHD)



      B302422E18
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 (L) - 1 (E)
      Lock switch pushed
      Below 1 Ω
      Lock switch not pushed
      10 kΩ or higher
      9 (UL) - 1 (E)
      Unlock switch pushed
      Below 1 Ω
      Unlock switch pushed
      10 kΩ or higher

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Master Switch Assembly)
      If the result is not as specified, replace the power window regulator master switch.



  1. Check the operation of the power window regulator master switch assembly. (for RHD)



      B302422E20
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 (L) - 9 (E)
      Lock switch pushed
      Below 1 Ω
      Lock switch not pushed
      10 kΩ or higher
      8 (UL) - 9 (E)
      Unlock switch pushed
      Below 1 Ω
      Unlock switch pushed
      10 kΩ or higher

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Master Switch Assembly)
      If the result is not as specified, replace the power window regulator master switch.