Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE LIGHTING SYSTEM (INT)
  1. Customizing using the intelligent tester

    NOTICE:
    1. When the customer requests a change in a function, first make sure that the function can be customized.
    2. Be sure to make a note of the current settings before customizing.
    3. When troubleshooting a function, first make sure that the function is set to the default setting.

    HINT:
    The following items can be customized.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.

    5. Select the setting by referring to the table below.

      Illuminated Entry 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      Lighting Time
      15 s
      Changes the lighting time after closing all of the doors. (It will fade out immediately if the power switch is turned from off to on (ACC) or on (IG).)
      7.5 s, 15 s or 30 s
      Main body ECU (Multiplex network body ECU)
      I/L when ACC OFF
      ON
      Lights up the power switch illumination, rear dome light* and personal light when the power switch is turned from on (ACC) or on (IG) to off.
      ON or OFF
      I/L ON W/Door Key Unlock
      ON
      Lights up the power switch illumination, rear dome light* and personal light when doors are unlocked using a mechanical key or door control transmitter.
      ON or OFF
      Room Light when Aprchd
      ON
      Lights up the power switch illumination, rear dome light* and personal light when a door control transmitter enters any actuation area around the doors.
      ON or OFF

      1. *: w/ Rear Dome Light