OUTER REAR VIEW MIRROR > DISASSEMBLY |
| 1. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY |
![]() |
Disengage the 2 claws.
Disconnect the connector and remove the side turn signal light assembly.
| 2. REMOVE OUTER MIRROR RETRACTOR |
![]() |
Cut the wire harness at the position shown in the illustration.
| *a | Cut the wire harness here |
![]() |
Remove the vinyl tape from the gasket.
![]() |
Disengage the 2 claws and 7 guides to remove the gasket.
![]() |
Disengage the 4 claws and remove the stay cover.
![]() |
Remove the 3 screws and stay.
![]() |
Remove the 3 screws and disconnect the unit drive assembly.
![]() |
Disengage the clamp.
Disconnect the connector and remove the unit drive assembly.
![]() |
Remove the 5 screws and reinforcement.
![]() |
Disconnect the connector.
Disengage the 2 clamps.
![]() |
Remove the wire harness as shown in the illustration.
![]() |
Remove the screw and retractor assembly.