Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > REASSEMBLY

for Preparation Click here



1. INSTALL OUTER MIRROR RETRACTOR


    B411116
  1. Install a new retractor assembly with the screw.



    B411117
  1. Connect the connector.

    NOTICE:
    Make sure to replace the wire harness with a new one.

  1. Engage the clamp.



    B411118
  1. Pass the wire harness through the visor body as shown in the illustration.



    B411119
  1. Connect the connector.

  1. Engage the 2 clamps.



    B411120
  1. Pass the wire harness through the retractor assembly as shown in the illustration.



    B308831
  1. Install the reinforcement with the 5 screws.



    B308829
  1. Install the unit drive assembly with the 3 screws.

    NOTICE:
    When installing the unit drive assembly, check that the wire harness is not caught.



    B308828
  1. Pass the wire harness through the stay, install the stay with 3 new screws.

    NOTICE:
    When installing the stay, check that the wire harness is not caught between the stay and visor body. Failure to do so may cause a short circuit.



    B308827
  1. Engage the 4 claws to install a new stay cover.



    B308826
  1. Pass the wire harness through a new gasket, engage the 7 guides and 2 claws to install a new gasket.

    NOTICE:
    Do not make gaps between the gasket and stay.



    B308836E01
  1. Wrap new vinyl tape as shown in the illustration.
    Text in Illustration 
    *1
    Vinyl Tape
    Area
    Measurement
    A
    45 mm (1.77 in.)

    NOTICE:
    Wrap the vinyl tape tightly around the wire harness to ensure that there are no gaps.



    B308837
  1. Connect the connector of the shorter wire harness to the adapter.

  1. Twist the longer wire harness as shown in the illustration and connect the connector to the adapter.



2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
  1. Connect the connector.

  1. Engage the 2 claws to install the side turn signal light assembly.