Home › Engine / Hybrid System › 1NZ-FXE ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REPAIR

for Preparation Click here



1. REPAIR INTAKE VALVE SEATS

NOTICE:
  1. Repair the seat while checking the seating position.
  2. Keep the lip free of foreign matter.



    A267072E01
  1. If the seating is too high on the valve face, use 20° and 45° cutters to correct the seat.
    Text in Illustration 
    *a
    Width

    Valve seat width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)



    A267073E01
  1. If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.
    Text in Illustration 
    *a
    Width

    Valve seat width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)

  1. Hand-lap the valve and valve seat with an abrasive compound.

  1. Check the valve seating position.



2. REPAIR EXHAUST VALVE SEATS

NOTICE:
  1. Repair the seat while checking the seating position.
  2. Keep the lip free of foreign matter.



    A267072E01
  1. If the seating is too high on the valve face, use 20° and 45° cutters to correct the seat.
    Text in Illustration 
    *a
    Width

    Valve seat width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)



    A267073E01
  1. If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.
    Text in Illustration 
    *a
    Width

    Valve seat width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)

  1. Hand-lap the valve and valve seat with an abrasive compound.

  1. Check the valve seating position.