Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR

ROOM TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

    NOTICE:
    Do not use a moulding remover to an area other than that shown in the illustration. Using a moulding remover in an area other than that shown in the illustration may result in deformation or damage to related parts.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



2. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)


    B301683
  1. Disengage the 3 clips and remove the No. 2 instrument panel register assembly.



3. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)


    B297457
  1. Disengage the 3 clips and remove the No. 1 instrument panel register assembly.



4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B301684E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301685
  1. Using a moulding remover, disengage the 12 clips and 10 guides to remove the instrument cluster finish panel garnish.



5. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL GARNISH


  1. for LHD:



      B307679
    1. Disengage the 3 claws, 8 clips and 3 guides, and remove the lower instrument cluster finish panel garnish as shown in the illustration.



  1. for RHD:



      B297484
    1. Disengage the 2 claws, 8 clips and 4 guides, and remove the lower instrument cluster finish panel garnish as shown in the illustration.



6. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    E308082
  1. Disengage the 4 clips.

  1. Disconnect the connector to remove the air conditioning control assembly.



7. REMOVE ROOM TEMPERATURE SENSOR (COOLER THERMISTOR)


    E238260
  1. Insert a screwdriver into the position shown in the illustration to disengage the 2 claws.



    E238261
  1. Disconnect the connector and aspirator and remove the room temperature sensor (cooler thermistor).