ENGINE UNIT > REMOVAL |
| 1. REMOVE NO. 2 EGR PIPE |
![]() |
Disconnect the wire harness clamp.
Disengage the clamp and disconnect the No. 2 water by-pass hose.
Remove the 2 bolts and 2 nuts.
Remove the No. 2 EGR pipe and 2 gaskets.
| 2. REMOVE EGR VALVE WITH COOLER ASSEMBLY |
![]() |
Disconnect the 2 connectors and wire harness clamp.
![]() |
Remove the bolt and wire harness clamp bracket.
![]() |
Disconnect the clamp, No. 4 water by-pass hose and No. 5 water by-pass hose.
![]() |
Remove the 2 bolts, nut and EGR valve bracket.
![]() |
Remove the 2 bolts, 2 nuts and EGR valve with cooler assembly.
Remove the gasket.
![]() |
Disconnect the No. 1 water by-pass hose.
Remove the 2 bolts, EGR valve assembly and gasket.
![]() |
Using an E8 "TORX" socket wrench, remove the 2 stud bolts.
| 3. REMOVE INTAKE MANIFOLD STAY |
![]() |
Remove the 2 bolts and intake manifold stay.
| 4. REMOVE INTAKE MANIFOLD |
![]() |
Disconnect the 4 wire harness clamps and water by-pass hose.
![]() |
Disconnect the fuel vapor feed hose and ventilation hose.
![]() |
Remove the 3 bolts, 2 nuts and intake manifold.
![]() |
Remove the ventilation hose.
![]() |
Remove the bolt and intake manifold insulator.
![]() |
Remove the No. 1 intake manifold to head gasket.
| 5. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and No. 1 exhaust manifold heat insulator.
| 6. REMOVE MANIFOLD SUPPORT BRACKET |
![]() |
Remove the 4 bolts and manifold support bracket.
| 7. REMOVE EXHAUST MANIFOLD |
![]() |
Disconnect the wire harness clamp and oxygen sensor connector.
![]() |
Remove the 3 bolts, 2 nuts and exhaust manifold.
Remove the exhaust manifold to head gasket.
| 8. REMOVE NO. 4 WATER BY-PASS HOSE |
![]() |
Disconnect the No. 4 water by-pass hose.
Remove the bolt and No. 4 water by-pass hose.
| 9. REMOVE NO. 1 WATER BY-PASS PIPE |
![]() |
Disconnect the water hose from the water inlet with thermostat sub-assembly.
Remove the 3 bolts and No. 1 water by-pass pipe.
| 10. REMOVE WIRE HARNESS CLAMP BRACKET (for LHD) |
![]() |
Remove the bolt and wire harness clamp bracket.
| 11. REMOVE STUD BOLT |
![]() |
Using an E7 "TORX" socket wrench, remove the stud bolt.
| 12. REMOVE ENGINE OIL LEVEL DIPSTICK |
Remove the engine oil level dipstick.
| 13. REMOVE IGNITION COIL ASSEMBLY |
![]() |
Disconnect the 4 No. 1 ignition coil connectors.
Remove the 4 bolts and 4 No. 1 ignition coils.