Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM

DTC    B1350    Speaker Circuit

for Preparation Click here


DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.
This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1350
Either of the following conditions is met:
  1. When sound output voltage is being monitored by the ECU, with the power switch on (IG), battery voltage 10 V or more, and warning sound being produced, a speaker circuit short condition continues for 1 second or more.
  2. When sound output voltage is being monitored by the ECU, with the power switch on (IG) and warning sound not being produced, a speaker circuit open condition continues for 5 seconds or more.
  1. Vehicle approaching speaker controller
  2. Vehicle approaching speaker assembly
  3. Harness or connector between vehicle approaching speaker controller and vehicle approaching speaker assembly

WIRING DIAGRAM


E282277E10


INSPECTION PROCEDURE

1.INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY
  1. Remove the vehicle approaching speaker assembly (Click here).

  1. Inspect the vehicle approaching speaker assembly (Click here).



NG
REPLACE VEHICLE APPROACHING SPEAKER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER ASSEMBLY)
  1. Disconnect the G85 vehicle approaching speaker controller connector.

  1. Disconnect the A73 vehicle approaching speaker assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G85-3 (SP+) - A73-1 (+)
    Always
    Below 1 Ω
    G85-8 (SP-) - A73-2 (-)
    Always
    Below 1 Ω
    G85-3 (SP+) or A73-1 (+) - Body ground
    Always
    10 kΩ or higher
    G85-8 (SP-) or A73-2 (-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER (Click here)