Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER

BATTERY BLOWER > INSPECTION

for Preparation Click here



1. INSPECT BATTERY COOLING BLOWER ASSEMBLY


  1. Inspect the battery cooling blower filter.

    HINT:
    1. It is not necessary to remove the front floor cover LH to inspect the battery cooling blower filter.
    2. Inspect the battery cooling blower filter with the battery cooling blower assembly installed to the vehicle.




      A369917E01
    1. Inspect the battery cooling blower filter.
      Text in Illustration 
      *1
      Battery Cooling Blower Filter

      Standard:
      No clogs or damage.

      NOTICE:
      If the battery cooling blower filter is damaged, replace the battery cooling blower filter.



  1. Clean the battery cooling blower filter.

    NOTICE:
    If the battery cooling blower filter is excessively dirty, replace it.

    HINT:
    1. It is not necessary to remove the front floor cover LH to clean the battery cooling blower filter.
    2. Clean the battery cooling blower filter with the battery cooling blower assembly installed to the vehicle.




      A369887
    1. Clean the battery cooling blower filter by hand or using a vacuum cleaner.

      NOTICE:
      1. Do not use compressed air.
      2. Do not use water or any other liquids when cleaning the filter.
      3. Do not use a wire brush or scrubber.
      4. Do not disassemble the battery cooling blower assembly.
      5. Do not allow any foreign matter to enter the battery cooling blower assembly.



  1. Replace the battery cooling blower filter.

    HINT:
    Replace the battery cooling blower filter with the battery cooling blower assembly installed to the vehicle.


    1. Remove the front floor cover LH.



    2. Remove the battery cooling blower filter from the battery cooling blower assembly.


      A369844E01


      Text in Illustration 
      *1
      Battery Cooling Blower Filter
      -
      -
      V100144
      Depression
      -
      -

      HINT:
      1. The battery cooling blower filter is secured with double-sided tape.
      2. Place a hand in the depression of the battery cooling blower assembly and remove the battery cooling blower filter.

    3. Wipe off any tape adhesive residue of the battery cooling blower assembly with cleaner.

    4. Remove the peeling paper from the face of a new battery cooling blower filter.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    5. Install the battery cooling blower filter to the battery cooling blower assembly.

      HINT:
      Press the battery cooling blower filter firmly to install it.

    6. Install the front floor cover LH.