Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    U0100-530    Lost Communication with ECM / PCM "A"

DTC    U0129-527    Lost Communication with Brake System Control Module

DTC    U0129-528    Lost Communication with Brake System Control Module

DTC    U0151-763    Communication Error from Airbag ECU to HV ECU

DTC    U0164-827    Communication Error from A/C ECU to HV ECU

DTC    U1107-436    Lost Communication with Power Management Module

for Preparation Click here


DESCRIPTION

  1. The power management control ECU transmits and receives signals via CAN communication to and from the ECM, skid control ECU assembly, airbag sensor assembly, and air conditioning amplifier assembly.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
U0100
530
Problem with CAN communication between the ECM and power management control ECU (CAN communication system malfunction)
CAN communication system
U0129
527
Problem with CAN communication (V BUS) between the skid control ECU assembly and power management control ECU (CAN communication system malfunction)
528
Problem with CAN communication between the skid control ECU assembly and power management control ECU (CAN communication system malfunction)
U0151
763
Problem with CAN communication between airbag sensor assembly and power management control ECU (CAN communication system malfunction)
U0164
827
Problem with CAN communication between air conditioning amplifier assembly and power management control ECU (CAN communication system malfunction)
U1107
436
Problem with CAN communication between the power source ECU and power management control ECU (CAN communication system malfunction)

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the power switch on (IG) and wait for 2 minutes or more.

1.CHECK DTC OUTPUT (ALL CODES)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: System select / Utility / All Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    Power management control ECU outputs P2532-772
    A
    Power management control ECU does not output P2532-772
    B

  1. Turn the power switch off.



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

GO TO DTC CHART (P2532-772) (Click here)