Home › Vehicle Exterior › BODY DIMENSIONS › FRONT SUSPENSION CROSSMEMBER
BM3210E _01 Vehicle Exterior _050453 BODY DIMENSIONS _0242309 FRONT SUSPENSION CROSSMEMBER F

BODY DIMENSIONS  FRONT SUSPENSION CROSSMEMBER  TWO-DIMENSIONAL DISTANCE  


HINT:
·

Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

·

In cases in which only one dimension is given, left and right are symmetrical.

·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Front Suspension Lower Arm Installation Hole φ17.5 (0.69)
B, b Front Suspension Crossmember Installation Hole φ22 (0.87)
C, c Steering Gear Box Installation Hole φ17 (0.67)
D, d Front Suspension Crossmember Standard Hole φ24 (0.94)

K131721C01
3.5,1.094 3.813,1.25 0.313,0.156 10 false *A 4.25,1.75 4.563,1.906 0.313,0.156 10 false *B 2.771,1.75 3.083,1.906 0.313,0.156 10 false *C 0.167,8.594 0.479,8.75 0.313,0.156 10 false *a
*A FRONT *B LH
*C RH - -
*a mm
(in.)
- -


K131722C01
1.333,4.667 1,4.667 1,4.667 1,3.781 false 2.771,1.917 3.083,2.073 0.313,0.156 10 false *A 4.25,1.917 4.563,2.073 0.313,0.156 10 false *B 1.417,4.583 1.729,4.74 0.313,0.156 10 false *a 2,5.51 2.313,5.667 0.313,0.156 10 false *b 0.167,8.594 0.479,8.75 0.313,0.156 10 false *c
*A LH *B RH
*a Imaginary Datum Line *b Height from Imaginary Datum Line
*c mm
(in.)
- -