Home › Vehicle Exterior › BODY DIMENSIONS › REAR SUSPENSION CROSSMEMBER
BM3210E _01 Vehicle Exterior _050453 BODY DIMENSIONS _0242324 REAR SUSPENSION CROSSMEMBER F

BODY DIMENSIONS  REAR SUSPENSION CROSSMEMBER  TWO-DIMENSIONAL DISTANCE  


HINT:
·

Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

·

In cases in which only one dimension is given, left and right are symmetrical.

·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Rear Suspension Crossmember Installation Hole φ24 (0.94)
B, b Rear Suspension No. 1 Lower Arm Installation Hole φ12.2 (0.48)
C, c Stabilizer Bracket Installation Nut M12 (0.47)
D, d Rear Suspension No. 2 Lower Arm Installation Hole 23.1X14.2
(0.91X0.56)
E, e Rear Suspension Crossmember Installation Hole φ24 (0.94)

K131724C01
3.5,1.094 3.813,1.25 0.313,0.156 10 false *A 4.25,1.75 4.563,1.906 0.313,0.156 10 false *B 2.771,1.75 3.083,1.906 0.313,0.156 10 false *C 0.167,8.594 0.479,8.75 0.313,0.156 10 false *a
*A FRONT *B LH
*C RH - -
*a mm
(in.)
- -


K131725C01
1.167,4.667 0.833,4.667 0.833,4.667 0.833,3.781 false 2.771,1.917 3.083,2.073 0.313,0.156 10 false *A 4.25,1.917 4.563,2.073 0.313,0.156 10 false *B 1.25,4.594 1.563,4.75 0.313,0.156 10 false *a 1.667,5.51 1.979,5.667 0.313,0.156 10 false *b 0.167,8.594 0.479,8.75 0.313,0.156 10 false *c
*A LH *B RH
*a Imaginary Datum Line *b Height from Imaginary Datum Line
*c mm
(in.)
- -